1. Lokacin shigar da polycarbonate m jirgi, ɗaga fim ɗin kariya a gefen gefen kwamfyutan kwamfyuta mai ƙarfi da kusan 10cm, ta yadda mai tsaka tsaki yana ɗaure ga m polycarbonate jirgi don cimma tasirin hana ruwa.

2. Don hana haɓakar thermal da ƙanƙara mai sanyi, lokacin shigar da katako mai ƙarfi na polycarbonate, aƙalla ɓangarorin haɓaka na 10MM ya kamata a ajiye su a haɗin gwiwa tsakanin zanen gado biyu (tare da tazarar ƙasa da 2M). Don manyan abubuwan shigarwa na nisa, keɓancewar faɗaɗawa da ƙulla sararin samaniya an ƙaddara ta hanyar haɓakar haɓakar zafin rana na faifan allon PC.

3. Bayan an shigar da katako mai ƙarfi na PC, cire fim ɗin kariya (mai gefe biyu) a cikin mako guda.

4. Idan kana buƙatar buga ramuka kai tsaye akan farantin polycarbonate mai ƙarfi yayin shigarwa, diamita na ramin gabaɗaya 50% ya fi girma fiye da diamita na aron. Ya kamata a yi amfani da ƙullun da kai ya fi diamita, kuma a ƙara gasket mai hana ruwa.

5. Kusoshi kada su kasance maƙarƙashiya yayin shigarwa, in ba haka ba madaidaicin katako na polycarbonate zai fashe kuma ya haifar da matsalolin ruwa.

6. Lokacin shigarwa tare da sealant, silicone tsaka tsaki, tsaka tsaki jerin sealant (nau'in barasa, Toshiba) ko biyu-gefe mai hana ruwa tef za a iya amfani da.

7. Ƙaƙƙarfan katako na polycarbonate yana da fina-finai masu kariya a bangarorin biyu, kuma fim ɗin kariya na kariya na anti-ultraviolet yana da alamar da aka buga, kuma wannan gefen yana fuskantar rana a lokacin shigarwa.